|
|
X-Spat Controller
-
Version
1.6.0
X-Spat Controller for A&G X-Spat DSPExpansion, is a
MIDI software that provides control over the 202
parameters of X-spat boX, X-Spat Card for Rosetta800
and X-Spat Adapter for Richmond Sound Design AB64. It
generates 3D paths for up to 4 stereo or 8 mono audio
sources and it is possible to recall complete
speakers and internal patchbay configurations using
MIDI program change messages. Modify the parameters
as you wish. Repeat the operation for all channels
and save your setup file in the hard disk. At any
time, you can select the button Send to send the
necessary MIDI Control Change messages to your X-Spat
system. You can control the following parameters.
Input Level: regulates the input volume of the
Spatializer for the selected channel. Input LPF
Cutoff: sets the cut off frequency of the first-
degree Low Pass filter for the selected channel. Gain
Enhance: increases or decreases the level of the
spatialized signal for the selected channel within
the area designated by the speakers. Input HPF
Cutoff: sets the first-degree high pass filter cutoff
frequency for the selected channel. Bell Factor: it
allows you to compensate for the speaker's
directionality for the output of the selected
channel. Attenuation: regulates the percentage of
level variation for the selected channel in relation
to the distance of the source from the center of the
virtual cube. Doppler Depth: sets the depth of the
Doppler effect for the selected channel. Stereo/Mono
Source Position Manager: set the position in the
virtual space of the audio sources. ITD Depth: sets
the depth of the ITD intervention for the selected
channel. Front-Rear Spectral Enhance: sets the depth
of intervention of the filter dedicated to the
simulation of the rear positioning of the source in
relation to the center of the virtual cube for the
selected channel. Speakers X,Y and Z Position.
|